SEON Trooper TR9 Guía de usuario descargar pdf (Pagina 7)

Docking Tray Installation

The TR9 DVR can be mounted horizontally (on the floor or on a shelf) or vertically

upright (against a wall or bulkhead).

CAUTION! Do not mount the TR9 DVR in an inverted position.

The DVR could fall from the docking tray when the door is opened, injuring the

operator and damaging the DVR.

Use one of the flat keys to unlock the docking tray door. Slide the DVR out of the

docking tray.

2 Use a Phillips screwdriver to remove the five machine screws that fasten the

termination panel to the docking tray. Remove the termination panel from the

docking tray.

Docking tray door lock

Machine screws (×5)

3 Install the cable grommet in the access hole where the wiring harnesses enter the

docking tray. Install the hole-plug in the unused access hole.

4 Use the four enclosed #10×¾” metal screws or #10×1” self drilling screws to fasten

the docking tray to a sturdy horizontal or vertical surface. Make sure the mounting

location allows access to the four machine screws that secure the termination panel

to the docking tray.

5 Install the wiring harnesses as described in the Wiring instructions starting on page

8 of this manual.

6 Fasten the termination panel to the docking tray using the five machine screws that

were removed in step

7 Slide the DVR into the docking tray. Close and lock the docking tray door.

Termination panel

Docking tray

DVR

Cable grommet

Docking tray

mounting holes (×4)

1 2 3 4 5 6 7 8 9 10 11 12 ... 41 42

Sin comentarios

SEON Trooper TR9 Guía de usuario Pagina 7