SEON Trooper TR9 Guía de usuario descargar pdf (Pagina 8)

Wiring the DVR

All TR9 wiring harnesses plug into connectors on the termination panel of the docking

tray. The termination panel must be removed from the docking tray to connect the

wiring harnesses. Follow the instructions on page 7 of this manual to remove the

termination panel and to install the cable grommet and hole plug in the docking tray

access holes.

NOTE: Audio input jacks 1 and 2 are connected in parallel with the audio inputs of

cameras 1 and 2, respectively. If you connect remote microphones to the audio input

jacks, the audio signals from the camera harness must be disconnected inside the

camera. See the

Camera Harness section of this manual on page 9 for details.

The wiring harnesses enter the docking tray through one of the cable access holes.

Leave enough slack in the cables to allow the termination panel to be removed with the

harnesses attached.

The wiring harnesses can be surface mounted or concealed. If a harness is surface

mounted, ensure that it is secured at frequent points and protected from sharp corners.

If a harness is concealed, pull it from the un-terminated end to minimize the size

requirements of conduits and access holes.

The standard wiring harness length is 20 feet (6m) long. Please contact Seon Design if

you need a longer harness.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 41 42

Sin comentarios

SEON Trooper TR9 Guía de usuario Pagina 8